Adjusting The Transmission Slack Chain - Yamaha FZ-16 Service Manual

1.
Remove:
Cover the brake master cylinder "1"
NOTE:
Be careful not to spill brake fluid
and do not let the master cylinder reservoir
overflow.
By making the purge hydraulic brake system,
Always make sure there is enough liquid
brake before operating the lever. If this
caution is ignored, the entry may occur
air in the hydraulic brake system,
significantly increasing the time
flushing procedure.
If the bleeding is difficult, it may be necessary to leave
the brake fluid settle for a few hours.
Repeat the procedure when small
Air bubbles are gone.
2.
Purge:
Hydraulic brake system
a.
Fill the brake fluid reservoir to
the appropriate level with the brake fluid
recommended.
b.
Assemble the diaphragm tank
brake master cylinder.
c.
Securely attach a plastic hose
transparent "1" in the bleed screw 2.
1
d.
Place the other end of the hose
a container.
e.
Slowly operate the brake lever
several times.
f.
Completely pull the brake lever without
release
NOTE:
1
NOTE:
2
NOTE:
3-16
g.
Loosen the bleed screw.
When you release the bleed screw, the pressure will be
released and cause the contact of the lever
brake with the throttle.
h.
Tighten the bleed screw and then release the
brake lever
i.
Repeat steps "e" to "h" until all
the air bubbles have disappeared from
brake fluid in the plastic hose.
j.
Tighten the bleed screw to specification.
Bleed screw:
6 Nm (0.6 m · kg, 4.3 ft · lb)
T.
R.
k.
Fill the brake fluid reservoir to the
appropriate level with the brake fluid
recommended.
Refer to "CHECKING THE LEVEL
BRAKE FLUID "on page 3-14
WARNING
After making the brake system purge
hydraulic brake check function.
3.
Assembly:
Cover the brake master cylinder
ADJUSTING THE SLACK CHAIN
TRANSMISSION
The slack in the chain must be
be verified at the point of greatest tension.
CAUTION
A chain tensioned excessively overloaded
engine and other vital parts and chain
You can get loose and damage the swingarm or
cause an accident. Therefore, keep the
tension within the drive chain
specification limits.
1.
I placed the vehicle on a flat surface
WARNING
Support the vehicle safely to avoid
there is a risk of falling.
Place the vehicle on the main stand, so
that the rear wheel is elevated.
CHASSIS