Inspection And Adjustment Column Address - Yamaha FZ-16 Service Manual

4
Spray the lubricant inside the chain between
inner and outer plates, rollers and
bearings.
5
After waiting for lubrication
15 minutes.
6
Excess lubricant must be cleaned
with a clean cloth before driving.
INSPECTION AND ADJUSTMENT COLUMN
ADDRESS
1.
Place the vehicle on a flat surface.
WARNING
Support the vehicle with safety to
there is no risk of falling.
NOTE:
Drive your vehicle to the center support so
that the front wheel is elevated.
2.
Check:
Steering column.
Hold the front fork legs and
gently move the fork.
Dura / flojaAjuste the column
direction.
3.
Remove:
Upper yoke
See "COLUMN
ADDRESS "on page 4-43
4.
Fit:
Steering column
a.
Remove the lock washer "1" nut
upper annular "2" rubber washer "3".
b.
Tighten the lower ring nut "4" key
of the nut on the steering column "5".
NOTE:
Set the torque wrench at a right angle
for the nut wrench the steering column.
5
Nut wrench address:
YSST-721
Lower ring nut (pair d
starting torque)
T.
R. 33 Nm (3.3 m · kg, 24 ft · lb)
c.
Loosen the lower ring nut "4" completely
and then tighten to specification with the key
of the nut of the steering column.
WARNING
Do not overtighten the lower ring nut.
Lower ring nut (torque
final torque)
T.
R.
22 Nm (2.2 m · kg, 16 ft · lb)
d.
Check that the steering column is not
loose or hard when you turn the fork completely
in both directions. If it feels hard, remove the
bottom bracket bearings and check the top
and bottom.
Refer to "STEERING"
on page 4-43.
e.
Assemble the rubber washer "3".
f.
Assemble the upper ring nut "2".
g. Tighten the nut finger upper annular
"2" and align the slots of both ring nuts.
If necessary, hold the lower ring nut
tighten the nut until the upper annular
slots are aligned.
NOTE:
Make sure the lock is properly seated
into slots in the ring nuts "b"
3-18
CHASSIS
4