Transmission Chain Lubrication; Specifications - Yamaha FZ-16 Service Manual

2.
Rotate the rear wheel to find the point with
greater tension in the chain.
3.
Check:
Clearance of the transmission chain "a"
Out of specification Adjust.
Chain slack
transmission:
30-40 mm
NOTE:
Measure the clearance between the drive chain
the drive shaft and the axis of the rear wheel.
4. Fit:
Clearance of the transmission chain.
a. Loosen the nut on the brake rod "1"
b. Loosen the nut "2" of the wheel axle
1
c. Turn the adjusting nuts "3" to adjust the
gap voltage of the specified string.
Address to
The chain is tensioned
Address b
The chain is loosened
NOTE:
To maintain proper alignment of the wheel,
adjust both sides equally.
e.
Secure the axle nut to the torque wheel
specified.
T.
R.
5.
Fit:
Free pedal brake
See "SETTING BRAKE
REAR " on page 3-14
6.
Align the rear axle
a.
To maintain proper alignment of the shaft.
The reference lines "1" in the swing
must correspond to the same diameter
outside of the washer "2" on both sides.
b.
After adjusting, tighten
2
each adjustment nut. Then tighten
the axle nut to specified torque.
CHAIN LUBRICATION
TRANSMISSION
The transmission chain consists of many
parts interact. If the string
transmission is not properly maintained,
will wear quickly. Therefore, their
Maintenance should be done, especially
when the vehicle is used in a high
powder.
It is recommended to use a chain cleaner
and a lubricant that is suitable for chain
with O-ring.
1.
ite all deposits of dust, dirt, mud,
or oil. during wash and air dry.
to
2.
Spray the chain with a degreaser
chain to remove fat deposition
for 5 minutes.
b
3.
Clean the chain with a clean cloth and wait
3-17
Spindle nut of the wheel:
90 Nm (9.0 m · kg, 65 ft · lb)
1
2
Recommended lubricant
Lubricant for chains with
O-ring
CHASSIS