Yamaha FZ-16 Service Manual page 99

d.
Measuring deformation of the brake disk
e.
If out of specification, repeat the
setting until the deformation of the disc
brake is within the specified
f.
If the deformation of the disc brake disk
you can not within specification,
replace the brake disc.
6.
Assembly:
Front Wheel
Refer to "FRONT WHEEL"
on page 4-6
CHANGING THE BRAKE
FRONT
NOTE:
When replacing the brake pads is not
disconnect the brake hose or
disassemble the brake caliper.
1.
Measure
Desgate limit of the brake pad "a"
EspecificaciónReemplace outside the
set of brake pads
Coating thickness of the
brake pads (inside)
4.5 mm
Limit 0.8 mm
Coating thickness of the
brake pads (exterior)
4.5 mm
Limit 0.8 mm
2.
Assembly:
Brake pads
Spring brake pads
NOTE:
Assemble the new brake pads and spring
new brake pads.
a.
Securely attach a plastic hose
transparent "1" bleed screw "2".
Place the other end of the hose
a container.
b. Loosen the bleed screw and push the piston
brake caliper with your fingers
c. Tighten the bleed screw
Bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb)
T.
R.
d. Assemble the brake pads and springs
new brake pads.
3. Check
Brake fluid level
Below the level mark
minimum "on" add brake fluid
recommended to the proper level.
Refer to "CHECKING
BRAKE FLUID LEVEL "on page 3-14.
Operation of the brake lever
to
4.
Feeling the soft or esponjosaPurgue
Brake system.
See "VENT SYSTEM
HYDRAULIC
4-20
FRONT BRAKE
Max.
Min
BRAKE"On page 3-15.