Removing The Handlebar; Check The Handle; Handlebar Assembly - Yamaha FZ-16 Service Manual

REMOVING THE HANDLEBAR

1.
I placed the vehicle on a flat surface
WARNING
Support the vehicle safely to avoid
there is a risk of falling.
2.
Remove:
•
Brake light switch front "1"
NOTE:
Press the latch to remove the light switch
front brake master cylinder brake.
3.
Remove:
•
Handlebar grip "1"
NOTE:
Blow compressed air between the left handlebar
and the handlebar grip, and gradually
push the handle out.

CHECK THE HANDLE

1.
Check:
•
Handlebar
Curves / cracks / damage Replace.
WARNING
Do not attempt to straighten bent handlebars and
that dangerously weakened.

HANDLEBAR ASSEMBLY

1. I placed the vehicle on a flat surface
WARNING
Support the vehicle with safety to
there is no risk of falling.
2.
Ensemble: l
•
Handlebar "1"
•
Handlebar top clamp "2"
Upper clamp screw
Handlebar
26 Nm (2.6 m kg, 19 ft lb)
T.
R.
CAUTION
First, tighten the screws on the
front of the handlebar clamp, and then
the rear.
Turn the handlebars to the left
and right. If no contact
fuel tank to adjust the position of the handlebar.
NOTE:
Align the marks "a" of the handlebar with the
upper surface of the clamp bracket
the handlebar.
2
3.
Assembly:
•
Support the clutch lever "1"
NOTE:
Align the slot in the lever bracket
clutch to match the mark "a"
on the handlebars.
4-32
HANDLE
2
1
to