Yamaha FZ-16 Service Manual page 47

1. Clutch cable
2. Overflow pipe
3. Throttle cable
4. Starter cable
5. Carburetor vent hose
6. AC magneto lead
7. Negative lead
8. Breather hose from the battery
9. Carburetor drain hose
10. Fuel line
11. Speaker Cable
12. Connector cover
13. Harness
14. Cable sensor unit
15. Switch wires left handlebar
16. Cables right handlebar switch
17. AIS hose
A. Cable clutch and starter cable through the guide
B. Overflow pipe through the left edge of the fuel tank
C. Throttle cable and starter cable through the guide
D. Attach the AC magneto lead frame clamp
E. Pass the breather hose from the battery and the carburetor drain hose to
through the holes in the hose joint
F. Pass the overflow pipe through the guide
G. Pass the wire harness cable, the sensor unit cables, switches
handlebar through the guide
H. Thread the speaker cord, after spending the overflow pipe through the guide
I. Pass the wire harness cable, the sensor unit cables, switches
handlebar through the guide
J. Inserting the projection of the connector cover the hole in chassis
K. After connecting the cables, all cables will be covered by the cover
connectors. No bare wires protruding from the connector cover.
GUIDING CABLES
2-30