SPEAKER VERIFICATION
1.Check:
•
Resistance of the horn
Replace out of specification
Coil resistance
Ù 1.95-2.25 at 20 ° C
a. Disconnect the connectors on the horn of the
the speaker terminals.
b. Connect the multimeter (Ù × 1) to terminals
of the horn.
Multimeter
•
Tester positive probe
terminal of the horn "1"
•
Tester negative probe
terminal of the horn "2"
c. Measure the resistance of the horn.
2. Check:
•
Sound the horn
Adjust or replace defective sound.
a. Connect a battery (12 V) to the speaker.
b. Turn the adjusting screw in direction "a" or
"B" until the specific sound is obtained.
to
1
2
b
7-42
ELECTRICAL COMPONENTS
VERIFICATION METER
FUEL
1. Remove:
•
Fuel tank
2. Remove:
•
Fuel gauge
3. Check:
•
Fuel gauge resistance
Out of specification Replace
fuel gauge
Fuel gauge
Resistance of the meter unit (full)
Ù -21.5 18.5 at 20 ° C (68 ° F)
Resistance of the meter unit (empty)
Ù 137-143 at 20 ° C (68 ° F)
a. Connect the multimeter
fuel gauge, as shown
Multimeter
•
Tester positive probe
orange / white "1"
•
Tester negative probe
green / black "2"
2
b. Move the fuel gauge float
the level of minimum and maximum.
c. Measuring the resistance of the fuel gauge.
(Ù × 100) in the coupler
1
ORW GB