Yamaha FZ-16 Service Manual page 147

c.
Align the "I" of the timing sprocket
"C" with the stationary mark "d" on the plate
Retention of the camshaft.
d.
Install the timing chain on the pinion
camshaft and then install the pinion
camshaft camshaft.
NOTE:
When installing the camshaft sprocket, make sure
to maintain the chain on the side
Exhaust so tensioned as possible.
CAUTION
Do not rotate the crankshaft when installing the tree
Cam to prevent damage or performance
Improper valve.
e.
While holding the camshaft, tighten
temporarily screw shaft pinion
Camshaft.
f.
Remove the cable from the supply chain.
4.
Install:
•
Packaging chain tensioner
New
distribution
•
Tensor of the distribution chain
a.
While gently pushing rod
tensor of the distribution chain to the
hand, turn it clockwise with a
thin screwdriver "1".
b.
With the rod of the chain tensioner
distribution rotated fully into the box
tensor of the distribution chain (with
the thin screwdriver still installed), install
gasket and chain tensioner
Distribution "2" in the cylinder body.
c.
tighten the chain tensioner
distribution "3" to the specified torque.
T.
b
to
d
c
d.
Remove the screwdriver, make sure the rod
tensor of the distribution chain back.
5.
Turn:
•
Crankshaft
(Several times clockwise)
6.
Check:
•
"I" mark "a"
Align the "I" of the magnet with the brand
stationary "b" in the magneto cover.
•
"I" mark "c"
Align the "I" of the camshaft sprocket
with the stationary mark "d" in the butt.
Outside the correct alignment
See the previous assembly steps.
5-10
Screw the chain tensioner
distribution
9 Nm (0.9 m · kg, 7 ft · lb)
R.
2
1
HEAD
1
3
b
to