TROUBLESHOOTING
The starter will not start.
NOTE:
•
Before troubleshooting, remove the following parts:
1.
Seat
2.
Side cover 1 and 2
1. Check the fuse.
Refer to the "VERIFICATION
FUSE "on page 7-34.
↓
OK
2. Check the battery.
See the section
"CHECKING AND CHARGING
BATTERY "on page 7-34.
OK ↓
3. Check operation of engine
boot.
Refer to the "VERIFICATION
ENGINE PERFORMANCE
START "on page 7-40.
↓
NG
4.
Check the engine starts.
Refer to the "VERIFICATION
ENGINE START "in the
page 5-33.
OK ↓
5.
Check the relay circuit court
starting.
Refer to the "VERIFICATION
RELAYS "on page 7-37.
OK ↓
6.
Check the starter relay.
Refer to the "VERIFICATION
RELAYS "on page 7-37.
↓
OK
7.
Check main switch.
Refer to the "VERIFICATION
SWITCH "on
page 7-30.
OK ↓
ELECTRIC STARTING SYSTEM
NG →
Replace the fuse.
NG →
• Clean the battery terminals
• Recharge or replace battery.
OK →
The
starter is good. Perform
electrical troubleshooting
ignition system, from step 5.
NG →
Repair or replace starter.
NG →
Replace the starter cut relay.
NG →
Replace the starter relay.
NG →
Replace the main switch.
7-9