Display Module - Genie Z80/60 Service Manual

Section 4 • Repair Procedures

Display Module

This table lists the various screens and menu options of the operating software. Some display menus are
for informational purpose only, while others can be used to change the machine operating parameters. The
key switch must be in the off position before entering the programming mode.
Always exit the programming mode before turning the red Emergency Stop button to the off position.
Screen To Enter
Power on,
configuration
message
Operator Default
Status With the key
switch on,
press the
and
at the same
time
4 - 2
Information Displayed
Boom Type(Z80,4WS,ETC.), Engine
Type, Software Version
Hour meter (On power up)
Engine Speed &
Engine Oil Pressure PSI (English) &
Engine Oil Pressure kPa (metric) &
Engine Temperature F (English) @
Engine Temperature C (metric) @
Primary Boom Angle Sensor
TT Level Sensor X
TT Level Sensor Y
Platform Angle
Battery Volts
Hydraulic Pressure PSI
Hydraulic Pressure kPa
Primary Boom Zone
Primary Boom Length
Secondary Boom Length
Secondary Boom Angle
Z-80/60
June 2011
Range
Engine temperature is not
displayed until engine is
above 100°F / 38°C
0-4500 PSI
0-31000 kPa
<=0 DEG, >0 DEG, =65
DEG
= 0', >0', >22'
= 0 FT, > 0 FT
= 0 DEG, .>0 DEG, = 65
DEG
Part No. 88619
REV E