Genie Z80/60 Service Manual page 156

Section 4 • Repair Procedures
ENGINES
6
4
Ford, Perkins,
Deutz BF4L-2011 models and
Continental TME27 models
8
6
4
Deutz F4L-913 models
4 - 54
1
3
5
2
1
3
5
7
2
6
4
4
6 Install the pump and mounting plate assembly
onto the engine. Apply Loctite
thread sealant to the mounting fasteners.
Perkins 704 models
Torque the pump mounting plate fasteners in
sequence to 14 ft-lbs / 19.1 Nm.
Deutz 913, Perkins 804 and GM models
Torque the pump mounting plate fasteners in
sequence to 28 ft-lbs / 38 Nm.
Deutz 2011 Models
Torque the pump mounting plate fasteners in
sequence to 46.7 ft-lbs / 63.3 Nm.
Ford Models
Torque the pump mounting plate fasteners in
sequence to 37 ft-lbs / 50.1 Nm.
Continental Models
Torque the pump mounting plate fasteners in
sequence to 23 ft-lbs / 31.2 Nm.
Component damage hazard.
When installing the pump, do not
force the pump coupler into the
flexplate or damage to the pump
shaft seal may occur.
Component damage hazard. Do
not force the drive pump during
installation or the flex plate teeth
may become damaged.
Z-80/60
June 2011
1
3
1
3
2 5
5
2
GM models
®
removable
Part No. 88619
REV C