Genie Z80/60 Service Manual page 222

Section 5 • Fault Codes
CONTROL SYSTEM FAULT CODES
Error Source
ENGINE SPEED
OIL PRESSURE
WATER/OIL TEMP
OIL PRESSURE SENSOR
WATER/OIL TEMP SENSOR
AXLE EXT/RET BUTTONS
CAN BUS
PRIMARY BOOM UP/DOWN
JOYSTICK
SECONDARY BOOM
JOYSTICK
PRIMARY
EXTEND/RETRACT
JOYSTICK
5 - 4
Error Type
Range check
(underspeed)
Range check (low oil
pressure)
Range check (high
temperature)
Fault check
Axle extend/retract disabled, display
Fault check
Value at 5.0 V
Value too high
Limited speed and direction frozen at
zero and neutral, alarm sounds.
Value too low
Value at 0 V
Joystick Speed and Direction frozen at
Not calibrated
Initiate one second beep of audible
Just calibrated
Value at 5.0 V
Value too high
Limited speed and direction frozen at
zero and neutral, alarm sounds.
Value too low
Value at 0 V
Joystick speed and direction frozen at
Not calibrated
Initiate one second beep of audible
Just calibrated
Value at 5.0 V
Value too high
Limited speed and direction frozen at
zero and neutral, alarm sounds.
Value too low
Value at 0 V
Joystick speed and direction frozen at
Not calibrated
Initiate one second beep of audible
Just calibrated
Effects
Display message on LCD.
Display message on LCD.
message on LCD.
Display message on LCD.
zero and neutral
warning device.
zero and neutral.
warning device.
zero and neutral.
warning device.
Z-80/60
June 2011
REV C
Recovery Actions
Power up controller with the problem
corrected.
Power up controller with the problem
corrected.
Power up controller with the problem
corrected.
Power up controller with the problem
corrected.
Power up controller with problem
corrected.
Calibrate joystick.
Self-clearing (transient)
Power up controller with problem
corrected.
Calibrate joystick.
Self-clearing (transient)
Power up controller with problem
corrected.
Calibrate joystick.
Self-clearing (transient)
Part No. 88619