Return To - Genie Z80/60 Service Manual

1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
June 2011 July 2013
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
REV F REV E
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
5 Do not start the engine.
6 Locate the drive/steer joystick.
7 Move the drive/steer joystick full stroke in the
forward direction and hold for 5 seconds, then
return to the center or neutral position.
8 Move the drive/steer joystick full stroke in the
reverse direction and hold for 5 seconds, then
return to the center or neutral position.
Result: The alarm at the ground controls should
sound for a successful calibration.
Steer functions:
1 Turn the key switch to the off position.
2 Press and hold the enter button
ground control panel while turning the key
switch to platform controls.
3 Press the minus button
enter button twice.
4 Use the scroll button
menu until
RESET STEER JOYSTICK DEFAULTS
displayed. Press the
then press the button.
5 Do not start the engine.
6 Locate the drive/steer joystick.
7 Move the drive/steer joystick or thumb rocker
switch (if equipped) full stroke in the left
direction and hold for 5 seconds, then return to
the center or neutral position.
Part No. 88619
on the
twice, then press the
to scroll through the
is
button to select ,
YES
Z-80/60
Section 4 • Repair Procedures
8 Move the drive/steer joystick or thumb rocker
switch (if equipped) full stroke in the right
direction and hold for 5 seconds, then return to
the center or neutral position.
Result: The alarm at the ground controls should
sound for a successful calibration.
Result: If the alarm does not sound, repeat
calibration procedure.
Primary boom extend/retract functions:
1 Turn the key switch to the off position.
2 Press and hold the enter button
ground control panel while turning the key
switch to platform controls.
3 Press the minus button
enter button twice.
4 Use the scroll button
menu until
RESET PRIMARY BOOM EXTEND
is displayed. Press the
JOYSTICK DEFAULTS
button to select , then press the
YES
5 Do not start the engine.
6 Locate the primary boom extend/retract
joystick.
7 Move the primary boom extend/retract joystick
full stroke in the extend direction and hold for 5
seconds, then return to the center or neutral
position.
PLATFORM CONTROLS
on the
twice, then press the
to scroll through the
/
RETRACT
button.
4 - 13