Genie Z80/60 Service Manual page 153

June 2011
REV C
Continental models:
7 Tag and disconnect the wire harness from the
oxygen sensor.
8 Remove the exhaust pipe heat shield fasteners
from the top of the muffler.
Burn Hazard. Hot engine parts can
cause severe burns.
9 Remove the muffler retainer bracket fasteners.
10 Remove the muffler fasteners securing the
muffler to the exhaust manifold. Remove the
muffler from the bracket.
11 Remove the relay housing from the muffler
mount. Do not disconnect the relays.
12 Disconnect and remove the ECM from the
muffler mount.
13 Close the shutoff valve on the Liquid Petroleum
Gas (LPG) tank by turning it clockwise
(if equipped).
14 Unbolt the EPR valve from the muffler mount.
Leave the hoses attached to the EPR valve.
15 Remove the muffler mount.
16 Support the drive pump with an appropriate
lifting device. Remove the pump plate mounting
fasteners.
17 Carefully pull the pump and bell housing
assembly away from the engine and secure it
from moving.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
18 Remove the flex plate mounting fasteners.
Remove the flex plate from the engine flywheel.
Part No. 88619
Deutz F4L-913 models:
7 Tag and disconnect the wiring from the bell
housing.
8 Remove the exhaust tailpipe and air inlet tube
U-bolts from the air cleaner mounting bracket.
Burn hazard. Hot engine parts can
cause severe burns.
9 Remove the fuel filter/water separator retaining
fasteners. Remove the filter/separator from the
engine. Do not disconnect the fuel hoses.
10 Remove the air cleaner mounting bracket
fasteners. Remove the air cleaner and bracket
assembly from the engine.
11 Support the drive pump with an appropriate
lifting device. Remove all of the remaining bell
housing to engine fasteners.
12 Carefully pull the pump and bell housing
assembly away from the engine and secure it
from moving.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
13 Remove the flex plate mounting fasteners,
and remove the flex plate from the engine
flywheel.
Z-80/60
Section 4 • Repair Procedures
ENGINES
4 - 51