Perform Engine Maintenance - Gm And Ford Models - Genie Z80/60 Service Manual

June 2011
REV G
B24
Perform Engine Maintenance -
GM and Ford Models
Engine specifications require that this procedure
be performed every 400 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
GM Models:
Required maintenance procedures and additional
engine information are available in the
GM 3.0L Operator Handbook
(GM part number 36100007).
GM 3.0L Operator Handbook
Genie part number
Ford Models:
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302).
Ford LRG-425 EFI Operator Handbook
Genie part number
Part No. 88619
Section 3 • Scheduled Maintenance Procedures
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
77738
84792
Z-80/60
CHECKLIST B PROCEDURES
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
3 - 43