Membrane Decal - Genie Z80/60 Service Manual

1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
June 2011 July 2013
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
REV F REV E
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
3 Locate the LED circuit board mounted to the
inside of the platform control box lid.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
Component damage hazard.
Electrostatic discharge (ESD) can
damage printed circuit board
components. Maintain firm contact
with a metal part of the machine
that is grounded at all times when
handling printed circuit boards OR
use a grounded wrist strap.
4 Carefully tag and disconnect the two ribbon
cables from the membrane circuit board.
5 Remove the LED circuit board retaining
fasteners.
6 Carefully remove the LED circuit board from the
platform control box lid.
Part No. 88619
1-2

Membrane Decal

How to Replace the Membrane
Decal
The membrane decal is a special decal that
consists of a decal with an electronic membrane
on the backside. The membrane contains touch
sensitive areas that, when pushed, activates the
machine functions. The membrane buttons
activate machine functions similar to toggle
switches, but do not have any moving parts.
1 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls.
2 Remove the platform control box lid retaining
fasteners. Open the control box lid.
3 Carefully tag and disconnect the two ribbon
cables from the membrane circuit board.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
Component damage hazard.
Electrostatic discharge (ESD) can
damage printed circuit board
components. Maintain firm contact
with a metal part of the machine
that is grounded at all times when
handling printed circuit boards OR
use a grounded wrist strap.
Z-80/60
Section 4 • Repair Procedures
PLATFORM CONTROLS
4 - 11