Grease The Turntable Rotation Bearing And Rotate Gear; Inspect The Fuel Filter/Water Separator - Diesel Models - Genie Z80/60 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-10
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that this procedure be
performed every 100 hours of operation. Perform
this procedure more often if dusty conditions exist.
Frequent application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Locate the grease fitting next to the ground
control box.
2 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of
4 to 5 inches / 10 to 13 cm at a time and repeat
this step until the entire bearing has been
greased.
3 Apply grease to each tooth of the drive gear,
located under the turntable.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent
3 - 14
A-11
Inspect the Fuel Filter/Water
Separator - Diesel Models
Note: Genie specifications require that this
procedure be performed every 100 hours or
monthly, whichever comes first.
Proper maintenance of the fuel filter/water
separator is essential for good engine
performance. Failure to perform this procedure can
lead to poor engine performance and/or hard
starting, and continued use may result in
component damge. Extremely dirty conditions may
require this procedure be performed more often.
Explosion and fire hazard. Engine
fuels are combustible. Perform this
procedure in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Note: Perform this procedure with the engine off.
Perkins Models:
1 Put on protective clothing and eye wear.
2 Open the engine side turntable cover and locate
the fuel filter/water separator next to the
hydraulic return filter on the bulkhead.
3 Inspect the filter bowl for water buildup.
Result: If water is present in the filter bowl
continue with steps 4 through 8.
Z-80/60
June 2011
REV E
Part No. 88619