Genie Z80/60 Service Manual page 109

June 2011
REV E
Screen To Enter
Sensor With the key
calibration switch off,
press and
hold the
button and
turn the key
switch to the
on position.
Release the
button
and press
.
Default With the key
Reset switch off,
press and
hold the
button and
turn the key
switch to the
on position.
Release the
button
and press
.
Part No. 88619
Information Displayed
Set Unit levels to gravity
Unit Level Y-axis Millivolts per degree
Unit Level X-axis Millivolts per degree
Set Platform level to gravity
Platform Level Sensor Millivolts per
degree
Reset Blue End Blue Side Steer Sensor
( / )
YES NO
Reset Yellow End Blue Side Steer
Sensor ( / )
YES NO
Reset Blue End Yellow Side Steer
Sensor ( / )
YES NO
Reset Yellow End Yellow Side Steer
Sensor ( / )
YES NO
Reset All Steer Sensors (
Reset Primary Boom Angle Sensor
( / )
YES NO
Primary Boom angle = 40deg (
Primary Boom angle = 70deg (
Reset Drive Functions (
Reset Boom Function Speeds (
Reset Lift Function Ramps (
Reset All (Machine Require Calibration)
( / )
YES NO
Clear All Safety Switch Faults (
Z-80/60
Section 4 • Repair Procedures
Range
/ )
YES NO
/ )
YES NO
/ )
YES NO
/ )
YES NO
/ )
YES NO
/ )
YES NO
/ )
YES NO
DISPLAY MODULE
4 - 7