Genie Z80/60 Service Manual page 73

June 2011
REV G
22 Install a wire jumper between pins 1 and 2 of
the Deutsch connector on the wire harness
removed in step 21.
Result: The display should show
23 Press and hold the low speed function enable
button and extend the secondary boom.
Result: The secondary boom should extend no
more than 12 inches / 30.5 cm and stop. The
engine should stop and the display will show
and
9
P B SAFETY FAULT
Result: If the engine does not stop and the
secondary boom continues to extend, the
secondary boom #1 retracted safety limit switch
(LSS1RS) is out of adjustment or the wiring
circuit is faulty and will need to be replaced or
repaired.
Bodily injury hazard. If the
secondary boom continues to
extend without stopping the
engine, stop immediately and
retract the secondary boom.
Failure to retract the secondary
boom could result in death or
serious injury.
24 Remove the wire jumpers installed in step 22
and connect the wire harness to LSS2AO.
25 Re-connect the Deutsch connector from the
secondary boom #2 angle safety limit switch
(LSS2AS) removed in step 20.
Part No. 88619
65
AT DEGREES
.
11
P SAFETY FAULT
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
.
Z-80/60 3 - 39