Replace The Engine Air Filter - Genie Z80/60 Service Manual

June 2011
REV E
9 Turn the key switch to ground control.
10 Test all machine functions from the ground
controls.
Result: All ground control functions should not
operate.
11 Press and hold the auxiliary power button.
Note: The engine must be shut off to access
auxiliary power.
12 Using auxiliary power, test all machine functions
from the ground controls.
Result: All ground control functions should
operate except extend.
13 Using a suitable lifting device, lift the additional
test weight from the platform.
Result: The platform overload indicator lights
should turn off at both the ground and platform
controls and the alarm should not sound.
Note: There may be an 2 second delay before the
overload indicator lights and alarm turn off.
14 Start the engine and test all machine functions
from the ground controls.
Result: All ground control functions should
operate normally.
15 Turn the key switch to platform control.
16 Test all machine functions from the platform
controls.
Result: All platform control functions should
operate.
Note: If the platform overload system is not
operating properly, Refer to 2-4, How to Calibrate
the Platform Overload System (if equipped).
17 Using a suitable lifting device, remove the
remaining test weights from the platform.
Part No. 88619
Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
C-4

Replace the Engine Air Filter

Engine specifications require that this procedure
be performed every 500 hours or 6 months,
whichever comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component
damage..
Note: Perform this procedure with the engine off.
1 Open the engine side cover. Empty the dust
discharge valve by pressing together the sides
of the discharge slot. Clean the discharge slot
as needed.
a
b
c
a
b
c
Z-80/60
retaining clamp
canister end cap
dust discharge valve
3 - 47