Genie Z80/60 Service Manual page 223

June 2011
REV C
Error Source
STEER JOYSTICK
PRIMARY BOOM UP/DOWN
SWITCHES ON TCON
SEC BOOM
UP/EXT/DWN/RET
SWITCHES ON TCON
PRIMARY BOOM EXT/RET
SWITCHES ON TCON
PRIMARY BOOM LENGTH
PRIMARY BOOM ANGLE
PRIMARY UP/DOWN SPEED
PRIMARY
EXTEND/RETRACT SPEED
PRIMARY BOOM UP/DOWN
FLOW VALVE
Part No. 88619
Error Type
Value at 5.0 V
Value too high
Limited speed and direction frozen at
zero and neutral, alarm sounds.
Value too low
Value at 0 V
Joystick speed and direction frozen at
Not calibrated
Initiate one second beep of audible
Just calibrated
Fault Check, (both Primary boom up/down disabled,
buttons pressed) display message on LCD.
Secondary boom up/extend and
Fault Check, (both
down/retract disabled, display message
buttons pressed)
Fault Check, (both Primary boom extend/retract disabled,
buttons pressed) display message on LCD.
Fault check
Display message on LCD.
(unknown length)
Fault check Allow only primary boom retract and
(unknown angle) down. Display message on LCD.
Display message on LCD and allow
Not calibrated
operation at default speed.
Display message on LCD and allow
Not calibrated
operation at default speed.
Normal function except threshold for
Not calibrated one or the other direction is zero.
Display message on LCD.
Initiate one second beep of audible
Just calibrated
Value at 5.0 V
Value Too High
Limited speed and direction frozen at
zero and neutral, alarm sounds..
Value Too Low
Value at 0 V
Z-80/60
CONTROL SYSTEM FAULT CODES
Effects
zero and neutral.
warning device.
on LCD.
warning device.
Section 5 • Fault Codes
Recovery Actions
Power up controller with problem
corrected.
Calibrate joystick.
Self-clearing (transient)
Power up controller with the problem
corrected.
Power up controller with the problem
corrected
Power up controller with the problem
corrected.
Power up controller with the problem
corrected.
Power up controller with the problem
corrected.
Perform auto calibrate procedure.
Perform auto calibrate procedure.
Calibrate thresholds.
Self-clearing (transient)
Power up controller with the problem
corrected.
Continued on next page
5 - 5