Genie Z80/60 Service Manual page 55

June 2011
REV G
4 Install the bolt that was just removed into the
anchor hole to secure the engine tray from
moving.
Crushing hazard. Failure to install
the bolt into the engine tray to
secure it from moving could result
in death or serious injury.
5 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
· Engine wiring harness
· Battery area wiring
6 Open the ground controls side turntable cover.
7 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
· Inside of the ground control box
· Hydraulic manifold wiring
· Hydraulic oil cooler wiring
8 Inspect for a liberal coating of dielectric grease
at the following location:
· All wire harness connectors to the ground
control box
· Hydraulic manifold wiring
9 Start the engine from the ground controls and
raise the secondary boom above the turntable
covers.
10 Inspect the turntable area for burnt, chafed and
pinched cables.
Part No. 88619
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
11 Lower the secondary boom to the stowed
position and turn the engine off.
12 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
· Cable track on the boom
· Cables on the boom and jib boom
· Jib boom/platform rotate manifold
· Inside of the platform control box
13 Remove the engine tray retaining fastener from
the engine tray anchor hole at the pivot end of
the engine tray.
14 Inspect for a liberal coating of dielectric grease
at the following location:
· All wire harness connectors to the platform
control box
· Hydraulic manifold wiring
15 Swing the engine tray in towards the machine.
16 Install the bolt that was just removed into the
original hole to secure the engine tray.
Crushing hazard. Failure to install
the bolt into the engine tray to
secure it from moving could result
in death or serious injury.
Z-80/60 3 - 21