How To Clear Secopndary Boom Safety Switch Faults - Genie Z80/60 Service Manual

Section 5 • Fault Codes
CONTROL SYSTEM FAULT CODES
Control System Fault Codes
How to Clear Secondary Boom
Safety Switch Faults
Note: Beginning with software release 2.0, the
secondary boom envelope switches will latch and
faults must be reset in software or through the
use of the TCON LCD. They will not clear by re-
powering the machine.
Note: There are two methods to reset the faults,
by using Web GPI or through the menu available
on the TCON LCD.
Using Web GPI
1 Connect the device containing the WEB GPI
software to the TCON with an RS-232 cable.
2 Select the Secondary Boom, then the Safety
Switch Status Flags screen.
3 Change any safety switch drop down menus
displaying to
FAULT OK
4 Exit Web GPI.
5 - 10
. Press .
SEND
Using the TCON LCD
Note: Take care when using this method to avoid
resetting threshold defaults.
1 With the key switch off, press and hold the
button and turn the key switch to the on
position. Release the
seconds and press the
2 Press the
SWITCH FAULTS
3 Select , then press the
YES
4 Press the
5 Select , then press the
YES
Note: This clears all latching faults, not standard
faults.
Z-80/60
June 2011
button after five
buttons.
button until
CLEAR ALL SAFETY
appears.
button.
button until appears.
EXIT
button.
Part No. 88619
REV C