Joysticks - Genie Z80/60 Service Manual

Section 4 • Repair Procedures
PLATFORM CONTROLS
4 Close the control box lid.
5 Remove the platform controls decal from the
platform control box.
6 Carefully remove the membrane decal from the
platform control box while guiding the ribbon
cables out of the control box lid.
7 Remove any decal adhesive from the control
box lid with a mild solvent.
Note: Do not allow any solvent to come in contact
with the membrane circuit board.
8 Install the new membrane decal while guiding
the ribbon cables through the control box lid.
Note: Be sure that all LED locations on the
membrane decal align with the LEDs on the
membrane circuit board.
9 Install a new platform controls decal over the
membrane decal.
10 Open the control box lid and carefully connect
the ribbon cables from the membrane decal to
the membrane circuit board.
4 - 12
1-3

Joysticks

How to Calibrate a Joystick
The joystick controllers on this machine utilize
digital Hall Effect technology for proportional
control. If a joystick controller is disconnected or
replaced, it must be calibrated before that
particular machine function will operate.
Note: The joystick must be calibrated before the
threshold, max-out or ramping can be set.
Note: After each joystick is calibrated, check the
display at the ground control box. There should be
no calibration faults shown on the display. If
calibration faults exist, repeat steps 1 through 8 for
that joystick controlled function.
Note: Perform this procedure with the engine off.
Drive functions:
1 Turn the key switch to the off position.
2 Press and hold the enter button
ground control panel while turning the key
switch to platform controls.
3 Press the minus button
enter button
4 Use the scroll button
menu until
RESET DRIVE JOYSTICK DEFAULTS
displayed. Press the
then press the
Z-80/60
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
June 2011 July 2013
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
on the
twice, then press the
twice.
to scroll through the
button to select
button.
Part No. 88619
REV E REV F
is
,
YES