4) Configure it to a Root AP.
WEC8500/ configure/ap ap_1# profile ap-mode rootAp
5) Restart the configured AP.
[Changing to Repeater AP]
The procedure of changing a W-EP AP to a Repeater AP is as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Check the registered AP list.
WEC8500/configure# show ap summary
3) Go to AP configuration mode of an AP that will be changed to a Repeater AP.
WEC8500/configure# ap ap_2
4) Configure it to a Repeat AP.
WEC8500/configure/ap ap_2# profile ap-mode repeaterAp
5) Restart the configured AP.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <General> menu in the sub-menus. To enable repeater service, configure
the INTERFACE GROUP in the Repeater Service of the window, select Enable in the
SERVICE, and click the <Apply> button.
© SAMSUNG Electronics Co., Ltd.
Figure 131. Root service management (1)
CHAPTER 5. WLAN Management
page 239 of 689