Dhcp Configuration; Dhcp Server - Samsung WEC8500 Operation Manual

5.4

DHCP Configuration

The DHCP service of APC consists of DHCP server, DHCP relay, and DHCP proxy.
5.4.1

DHCP Server

5.4.1.1 DHCP Server Configuration
A DHCP server in the APC dynamically allocates an IP address to a client.
Configuration using CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure #
2) To enable or disable the DHCP server, enter the 'ip dhcp' command. Use 'no' in front
of the command to disable the configuration.

ip dhcp enable

no ip dhcp enable
3) To check configuration information, use the 'show ip dhcp' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<DHCP>  <Internal Server> menu in the sub-menus.
Enable/Disable the DHCP SERVER SERVICE item in the Internal Server window to
enable or disable a DHCP server.
© SAMSUNG Electronics Co., Ltd.
Figure 144. DHCP server configuration
CHAPTER 5. WLAN Management
page 262 of 689