3.9
Deep Packet Inspection
It supports QoS by application. It may allow drop, bandwidth contract, and DSCP marking
and it provides statistics by detailed category. The application of DPI in a unit of WLAN is
possible and it also provides a monitoring function.
3.9.1
Configuring Profile and Application Rule
A profile is a set of application rules and each rule includes the QoS settings of the
application.
The profile must set at least one application rule.
Configuration using CLI
1) Enter the DPI Configuration mode.
APC# configure terminal
APC/configure# dpi
APC/configure/dpi#
2) Make a profile and add an application rule.
APC/configure/dpi# profile [NAME]
APC/configure/dpi/profile [NAME]# rule [APPLICATION]
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# action permit
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# mark [DSCP]
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# bw-contract
upstream [BW_CNT]
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# bw-contract
downstream [BW_CNT]
APC/configure/dpi/profile [NAME]# enable
Parameter
NAME
APPLICATION
DSCP
BW_CNT
3) Designate a WLAN where the profile is applied.
APC# configure terminal
APC/configure# wlan [ID]
APC/configure/wlan [ID]# dpi-profile [NAME]
© SAMSUNG Electronics Co., Ltd.
Profile name
Application name
DSCP value
Bandwidth Contract. Kbps
CHAPTER 3. Data Network Function
Description
page 144 of 689