Figure 57. Time Profile Configuration Window (2) - Samsung WEC8500 Operation Manual

Select an item in the list and perform detail configuration.
After finishing configuration in the window, click the <Apply> button to apply it to the
system.
3.5.5.2 Applying to ACL
Configuration using CLI
1) Go to the fqm mode to configure the configure  ACL rule of CLI.
APC# configure terminal
APC/configure# fqm-mode
2) Apply a time-profile to ACL. The 'no' parameter is used to delete a time profile.

access-list ip [ACL_NAME] time-profile [PROFILE_NAME]

no access-list ip [ACL_NAME] time-profile [PROFILE_NAME]
Parameter
ACL_NAME
PROFILE_NAME
An example of applying 't1' to 'acl' is shown below.
APC# configure terminal
APC/configure# fqm-mode
access-list ip acl1 time-profile t1
3) To check the configuration information, use the 'show running-config network'
command.
© SAMSUNG Electronics Co., Ltd.

Figure 57. Time Profile Configuration Window (2)

ACL name to configure
Name of a time profile to configure
CHAPTER 3. Data Network Function
Description
page 133 of 689