Ac Configuration - Samsung WEC8500 Operation Manual

6.1.3

802.11ac Configuration

The 802.11ac configuration is as follows:
Configuration using CLI
1) Go to configure radio mode of 80211a to configure.
WEC8500# configure terminal
WEC8500/configure# 80211a
2) Enter 11ac-support mode.
WEC8500/configure/80211a#11ac-support
3) Configure the AP so that it can support the 802.11ac property.
WEC8500/configure/80211a/11ac-support# enable [AP_ID]
GROUP_ID {all-ap/active-ap}/global]
Parameter
AP_ID
GROUP_ID
all-ap
active-ap
4) Configure the Modulation and Coding Scheme (MCS) rate.
WEC8500/configure/80211a/11ac-support# mcs num-ss [SPATIAL STREAM ]
global
Parameter
SPATIAL STREAM
AP_ID
5) To check the configured 11ac-support information, use the 'show 80211a radio-config
ap [AP_ID]' command.
© SAMSUNG Electronics Co., Ltd.
Description
ID of the AP (range: 1-500)
ID of the AP group
Applies to all APs in the group
Applies to all live APs in the group
Description
Number of spatial streams (range: 2~3)
ID of the AP (range: 1-500)
CHAPTER 6. Wi-Fi Configuration
page 287 of 689