Multicast To Unicast - Samsung WEC8500 Operation Manual

3.6

Multicast to Unicast

Execute the 'show multi2uni-list' command to check the list of wireless terminals that use
the multicast to unicast function.
3.7 IP Multicast Configuration
3.7.1 IP Multicast Routing Configuration
Configuration using CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Enable or disable the routing function for IP multicast.

ip multicast-routing: Enable

no ip multicast-routing: Disable
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Multicast>  <IP Multicast> menu in the sub-menus.
After selecting Enable/Disable in the IP Multicast window, click the <Apply> button to
apply the configuration.
3.7.2 PIM Configuration
As a multicast layer3 transmission protocol, the PIM has two modes, i.e. Dense mode and
Sparse mode. The WEC8500 supports only PIM Sparse mode and the PIM Sparse mode
can be configured for each interface.
Configuration using CLI
1) Go to configure of CLI  mode where you want to perform configuration.
WEC8500# configure terminal
WEC8500/configure# interface ge2
© SAMSUNG Electronics Co., Ltd.
Figure 59. IP Multicast Configuration Window
CHAPTER 3. Data Network Function
page 138 of 689