Figure 102. Window For Configuring Local Bridging Forwarding Of Remote Ap Group - Samsung WEC8500 Operation Manual

Figure 102. Window for Configuring Local Bridging Forwarding of Remote AP Group

4.2.2.6 Setup Remote AP Group DHCP
If you assign some AP which is included in Remote AP Group as a DHCP server AP. You
can support DHCP service without another DHCP server.
Support a function to assign a specific IP address at a specific MAC address, or supports IP
address range which will be assigned to DHCP Server, Lease Time,
Configuration using CLI
Excutes following commands to configure Remote AP Group's DHCP.
1) Enter configure  Remote AP Group DHCP setup mode using CLI.
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group [remote-ap-group-name]
WEC8500/configure/ap-group/[remote-ap-group-name]#remote
2) Enable/disable DHCP Server AP for using as a DHCP Server.
 server-ap [AP PROFILE NAME]

no server-ap
4) Can check DHCP information using 'show ap-group remote dhcp summary' command.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
page 197 of 689