Setting Ap Parameters - Samsung WEC8500 Operation Manual

7.15.3 Setting AP Parameters

Station-based Adaptive Load Balancing operates as the default value of the setting of the
AP group but it is possible to set other parameter value to an individual AP. Because it
operates in a radio unit, the parameters to change must be set to the individual radio of the
corresponding AP must be set.
Configuration using CLI
To set AP parameters, execute the command as follows:
1) Go to the load-balancing configuration mode in configure  AP of CLI.
APC# configure terminal
APC/configure# ap ap_1
APC/configure/ap ap_1# load-balancing
APC/configure/ap ap_1/load-balancing#
2) Go to the radio to perform the Station-based Adaptive Load Balancing function.
APC/configure/ap ap_1/load-balancing# radio 1
APC/configure/ap ap_1/load-balancing/radio 1#
3) Activate load balancing in the corresponding radio.

enable
4) Set the station threshold to perform the Load Balancing function.

interval [NUMBER]
Parameter
NUMBER
5) Set the station threshold to perform the Load Balancing function.

threshold [NUMBER]
Parameter
NUMBER
6) Set the time of blocking the reconnection after the load of the station is now balanced.

kickout-timeout [NUMBER]
© SAMSUNG Electronics Co., Ltd.
Interval for performing load balancing (sec)
Station threshold as the standard for the performance of load
balancing
CHAPTER 7. WLAN Additional Services
Description
Description
page 374 of 689