Samsung WEC8500 Operation Manual page 175

4.2.1.2 Adding/Removing APs
To aid management of APs in groups, the APC allows addition/removal of APs to/from AP
groups.
Configuration using CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group or enter the AP group configuration mode.

ap-group [AP_GROUP_NAME]
3) Add/remove an AP to/from the AP group. Use 'no' parameter in front of the command
to delete an AP from the AP group. However, you cannot delete an AP from a default
AP group. If you delete an AP from groups other than the default group, the deleted AP
is then included in the default AP group.

add-ap [AP_NAME]

no add-ap [AP_NAME]
4) Use the 'show ap-group summary' command to check the AP group information.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
page 175 of 689