Nmp V3 User - Samsung WEC8500 Operation Manual

Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<SNMP> <APC>  <Trap Receiver> menu in the sub-menus.
When you click the <Add> button in the Trap Receiver window, the trap creation window
is displayed. When you enter a configuration value and click the <Apply> button, the
configuration is applied.

10.1.3 NMP v3 User

Using SNMP v3 User configuration, you can assign access rights of read-only or read-write
for each users, and limit configuration rights.
Configuration using CLI
To add SNMP v3 User, excute following command.
1) Enter to configure mode of CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Add SNMP v3 User.

snmp user [USER_NAME] [ACCESS] [AUTH_PROTOCOL]
[AUTH_KEY] [PRIV_PROTOCOL] [PRIV_KEY]
Parameter
USER_NAME
ACCESS
AUTH_PROTOCOL
AUTH_KEY
PRIV_PROTOCOL
© SAMSUNG Electronics Co., Ltd.
Figure 269. SNMP trap configuration
SNMP v3 user name to be added.
Access rights (rw/ro)
- rw: read-write rights
- ro: read-only rights
Authentication Protocol
- MD5: Message-Digest algorithm 5
- SHA: Secure Hash Algorithm
Authentication Key
Privacy Protocol
- DES: Data Encryption Standard
CHAPTER 10. System Management
Description
page 471 of 689