Managing Interface Group - Samsung WEC8500 Operation Manual

3.2.2

Managing Interface Group

To use WLAN and other services, it is necessary to configure an interface into an interface
group.
Configuration using CLI
An example of entering into the group configuration mode of ifg_01 interface is shown
below.
WEC8500# configure terminal
WEC8500/configure# if-group ifg_01
Interface Group related commands are as follows:
[Creating or Deleting Interface group]
This command creates an interface group. Use 'no' parameter to delete an interface group.

if-group [INTERFACE_GROUP_NAME]

no if-group [INTERFACE_GROUP_NAME]
[Adding or deleting Interface]
This command adds an interface to an interface group being configured. Use 'no'
parameter to delete an interface.

add-if [INTERFACE_IP_ADDRESS]

no add-if [INTERFACE_ IP_ADDRESS]
[Retrieving Interface Group Status]
This command retrieves the configuration status of an interface group.

show if-group
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Interfaces Groups> menu in the sub-menus. Click the <Add> or
<Delete> button to add or delete an interface group.
© SAMSUNG Electronics Co., Ltd.
Figure 40. Interface Group Window (1)
CHAPTER 3. Data Network Function
page 68 of 689