Spanning Tree - Samsung WEC8500 Operation Manual

3.3.3

Spanning Tree

Configuration using CLI
To set up spanning tree related functions, go to configure mode by executing the following
command.
WEC8500# configure terminal
The related command is as follows.
[bridge forward-time]
This command configures the forward time of a bridge. The 'no' parameter is used for
default configuration.

bridge 1 forward-time [FORWARD_DELAY]

no bridge 1 forward-time
Parameter
FORWARD_DELAY
[bridge hello-time]
This command configures the hello time of a bridge. The time required when a bridged
LAN is changed to Bridge Protocol Data Units (BPDUs) is called as hello-time. The 'no'
parameter is used for default configuration.

bridge 1 hello-time [HELLOTIME]

no bridge 1 hello-time
Parameter
HELLOTIME
[bridge instance priority]
This command configures the bridge priority of MST instance. The 'no' parameter is used
to delete priority.

bridge 1 instance [INSTANCE_ID] priority [BRIDGE_PRIORITY]

no bridge 1 instance [INSTANCE_ID]
Parameter
INSTANCE_ID
BRIDGE_PRIORITY
© SAMSUNG Electronics Co., Ltd.
Description
Forward time delay (range: 4-30 s, default: 15)
Description
Hello BPDU interval (range: 1-10 s)
Description
Instance ID (range: 1-64)
Bridge priority (range: 0-61440)
CHAPTER 3. Data Network Function
page 75 of 689