Nat And Firewall Configuration - Samsung WEC8500 Operation Manual

8.4

NAT and Firewall Configuration

The APC provides the NAT and firewall function to provide stable network to a WLAN user.
8.4.1 Firewall Configuration
Configuration using CLI
[Firewall Configuration]
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Configure the accelerator function of a firewall.
WEC8500/configure# firewall enable
[Firewall Configuration using Access List]
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Create an access-list.
WEC8500/configure# access-list fw fw4 deny tcp any any eq 23
3) Configure a firewall to the interface using an access-list.
WEC8500/configure# interface vlan1.10
WEC8500/configure/interface vlan1.10# ip access-group fw forward fw4
WEC8500/configure/interface vlan1.10# exit
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Security>  <Firewall>  <General> menu in the sub-menus. You can configure
whether to use a firewall.
© SAMSUNG Electronics Co., Ltd.
Figure 232. Firewall configuration (1)
CHAPTER 8. Security
page 425 of 689