Figure 90. General Configuration Window For Ap Group - Samsung WEC8500 Operation Manual

Parameter
PRIMARY-APC
SECONDARY-APC
TERTIARY-APC
5) Use the 'show ap-group detail [AP_GROUP_NAME]' command to check the AP
group information.
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, select <AP Groups>
in the submenu, and then select an AP group to configure. In the 'General' tab of the AP
group, configure the necessary settings. If the OVERWRITE AP CONFIG checkbox is
selected, the respective setting is applied to all APs within the group.
© SAMSUNG Electronics Co., Ltd.
AP are used.
- apc-referral: The APC list configured for the APC is used as the
discovery list.
- DHCP: The APC list information relayed by DHCP option 138 (IPv4)
or option 52 (IPv6) is used as the discovery list.
- auto: Discovery type is automatically changed by the AP for automatic
connection to the APC.
This is the name of the primary APC server. The AP attempts to
connect to this APC first.
This is the name of the secondary APC server. If the AP is unable to
connect to the primary APC, the AP attempts to connect to this APC on
its second connection attempt.
This is the name of the tertiary APC server. If the AP is unable to
connect to the secondary APC, the AP attempts to connect to this APC
on its third connection attempt. The WEC8050 model does not support
Tertiary-APC.

Figure 90. General Configuration Window for AP Group

CHAPTER 4. AP Connection Management
Description
page 174 of 689