Figure 105. Ap Time Synchronization Configuration Options - Samsung WEC8500 Operation Manual

2) Configure how to transmit the time information to an AP using 'ac-stamp' and
configure the interval.

mode ac-stamp

ac-stamp-interval [INTERVAL]
3) To check the information, execute the 'show apc ap-time-config' command.
Configuring NTP type using CLI
1) Go to configure  apc  ap-time-config configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc# ap-time-config
WEC8500/configure/apc/ap-time-config#
2) Add the NTP server information to transmit to an AP. Maximum 10 NTP server
information can be added. To delete the configured NTP server information, enter 'no'
parameter in front of the command

add-ntp [NTP_SERVER_ADDRESS]

no add-ntp [NTP_SERVER_ADDRESS]

ntp-interval [NUMBER]
3) Configure the method of transmitting the time information to an AP as 'ntp'.

mode ntp
4) Use the 'show apc ap-time-config' command to check the configured information.
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, select <NTP> in the
submenu, and then select a time setting mode of the AP (TimeStamp or NTP), timestamp
interval, and NTP polling interval. Also, you can add/remove NTP server from which to
fetch time access information for the AP.
© SAMSUNG Electronics Co., Ltd.

Figure 105. AP Time Synchronization Configuration Options

CHAPTER 4. AP Connection Management
page 201 of 689