Mcs Configuration Management By Wlan - Samsung WEC8500 Operation Manual

5.1.5

MCS Configuration Management by WLAN

This is a function of configuring data rate and MCS by WLAN. You can configure MCS,
etc. by each WLAN differently because it is necessary to configure MCS, etc. differently
depending on the types of services such as FMC.
Configuration using CLI
1) Go to configure  WLAN configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
2) Go to 80211a or 80211b depending on the bandwidth to configure.
WEC8500/configure/wlan 1# 80211a
WEC8500/configure/wlan 1/80211a#
3) Configure the data rate. The settings described as shown below can be made only
when the corresponding WLAN is set to be disabled.
WEC8500/configure/wlan 1/80211a# rate [MODE][RATE]
Parameter
Mode
RATE
4) Configure the 802.11n Modulation and Coding Scheme (MCS) rate.
WEC8500/configure/wlan 1/80211a# mcs-11n [RATE]
Parameter
RATE
© SAMSUNG Electronics Co., Ltd.
Mode (basic/supported)
- Basic: Basic rate supported for a terminal to access to an AP.
- Supported: A connected terminal that supports the supported
rate can communicate with an AP at the supported rate.
Data rate
- Range for 80211a: 6, 9, 12, 18, 24, 36, 48, or 54 Mbps
- Range for 80211b: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, or 54
Mbps
MSC rate (Range: 0~23)
CHAPTER 5. WLAN Management
Description
Description
page 241 of 689