Igmp Snooping - Samsung WEC8500 Operation Manual

3.8

IGMP Snooping

Configuration using CLI
Use the 'ip igmp snooping' command to enable or disable Internet Group Management
Protocol (IGMP) Snooping.

ip igmp snooping

no ip igmp snooping
When this command is executed in the Configure mode, the IGMP Snooping of a bridge is
enabled or disabled. If it is executed in the interface mode, the IGMP Snooping of an
interface is enabled or disabled.
Configuring the IGMP Snooping of a bridge:
WEC8500# configure terminal
WEC8500/configure# ip igmp snooping
Configuring the IGMP Snooping of a VLAN interface:
WEC8500# configure terminal
WEC8500/configure# interface vlan1.10
WEC8500/configure/interface vlan1.10# ip igmp snooping
In addition, a specific function of the IGMP Snooping functions of a VLAN interface can
be enabled or disabled as shown in the below command.
[ip igmp snooping fast-leave]
This command enables or disables the Fast-Leave function. (Default: Enable status)

ip igmp snooping fast-leave

no ip igmp snooping fast-leave
[ip igmp snooping querier]
This command enables or disables the Querier function. (Default: Enable status)

ip igmp snooping querier

no ip igmp snooping querier
[ip igmp snooping report-suppression]
This command enables or disables the Report-suppression function. (Default: Enable
status)

ip igmp snooping report-suppression

no ip igmp snooping report-suppression
© SAMSUNG Electronics Co., Ltd.
CHAPTER 3. Data Network Function
page 141 of 689