Configuration Using Cli; Wec8500# Configure Terminal; Management Interface Configuration - Samsung WEC8500 Operation Manual

Wireless enterprise access point controller

Hide thumbs Also See for WEC8500:

Table of Contents

The APC can communicate with a W-EP wireless LAN AP using management interface.

This is one of the information that must be configured first of all for wireless LAN service.

Configuration using CLI

To configure management interface, execute the command as follows:

1) Go to the configure mode of the CLI.

WEC8500/configure#

2) Configure a management interface.

apc ap-mgmt-if [IP_ADDRESS]

3) To check the configured IP information, use the 'show apc summary' command.

Configuration using Web UI

In the menu bar of <WEC Main window>, select <Configuration> and then select the

<Controller>  <General> menu in the sub-menus.

After entering a configuration in the AP Management of the window, click the <Apply>

IP address of APC that is used for communication with a W-EP

wireless LAN AP

Figure 83. Management interface configuration

CHAPTER 4. AP Connection Management

page 160 of 689