Vlan Configuration - Samsung WEC8500 Operation Manual

3.3

VLAN Configuration

3.3.1 VLAN
Configuration using CLI
To configure VLAN, go to the VLAN interface mode by executing the following command.
WEC8500# configure terminal
WEC8500/configure# interface vlan
WEC8500/configure/interface vlan#
The related command is shown below and the range of VLAN ID is 1-4094.
[vlan bridge]
This command creates VLAN. The 'no' parameter is used to delete VLAN.

vlan [VLAN_ID] bridge 1

no vlan [VLAN_ID] bridge 1
[switchport access vlan]
This command set the VLAN mode to the access or hybrid mode. The 'no' parameter is
used to delete the VLAN configuration.

switchport {access/hybrid} vlan [VLAN_ID]
[switchport mode]
This command configures the mode of switch port. The 'no' parameter is used to delete the
configuration.

switchport mode {access/hybrid/trunk}

no switchport mode
[switchport hybrid allowed vlan]
This command configures the mode of switch port to hybrid. The 'no' parameter is used to
delete the configuration.

switchport hybrid allowed vlan: Configures VLAN to hybrid.

switchport hybrid allowed vlan all: Configures all the allowed VLANs to hybrid.

switchport hybrid allowed vlan none: Stops VLAN data transmission/reception.

switchport hybrid allowed vlan add [VLAN_ID]: Adds VLAN to the hybrid mode.

switchport hybrid allowed vlan remove [VLAN_ID]: Deletes VLAN from the hybrid
mode.

no switchport hybrid vlan: Deletes all the hybrid settings.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 3. Data Network Function
page 70 of 689