Security And Authentication - Samsung WEC8500 Operation Manual

5.3

Security and Authentication

The Samsung W-EP AP/APC supports the security and authentication function defined in
the IEEE 802.11-based wireless LAN security standard and its main mechanism is as
follows:

Wired Equivalent Privacy (WEP)

Wi-Fi Protected Access Version 1 (WPA1), Wi-Fi Protected Access Version 2 (WPA2)

Authentication type: Pre-Shared Key (PSK), 802.1X

Encryption type: Temporal Key Integrity Protocol (TKIP), AES-CCMP
When a new WLAN is added, the initial WLAN security configuration becomes all
disabled. Therefore, an operator must configure the security function.
5.3.1 Initialization of WLAN Security Function
This is a procedure to disable WLAN, where the security function is configured, to the
initial status.
Configuration using CLI
An example of initializing the security function of wlan 1 is show below.
1) Go to configure  wlan configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
2) After entering into the security configuration mode, use the 'setDefault' command to
initialize the security configuration.
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# setDefault
3) After applying the changed configuration, exit the security configuration mode.
WEC8500/configure/wlan 1/security# apply
WEC8500/configure/wlan 1/security# exit
4) To check configuration information, use the 'show wlan security summary' command.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 5. WLAN Management
page 247 of 689