Parameter
NUMBER
5) Set the station threshold to perform the Load Balancing function.
threshold [NUMBER]
Parameter
NUMBER
6) Set the time of blocking the reconnection after the load of the station is now balanced.
kickout-timeout [NUMBER]
Parameter
NUMBER
7) To lead the station which performs load balancing to connect to a specific AP, set the
probe response limit time to other APs.
no-probe-timeout [NUMBER]
Parameter
NUMBER
8) The rssi-high value is a criterion for excluding candidates for load balancing to be
selected. The station with the RSSI value higher than the set value does not attempt at
load balancing (In case of the active mode, N/A).
rssi-high [NUMBER]
Parameter
NUMBER
9) The rssi-low value is a criterion for selecting a sticky station. The station with the
RSSI value lower than the set value always attempts at load balancing.
rssi-low [NUMBER]
Parameter
NUMBER
© SAMSUNG Electronics Co., Ltd.
Interval for performing load balancing (sec)
Station threshold as the standard for the performance of load
balancing
Reconnection limit time (0~100 sec.)
Probe response limit time (0~100 sec.)
RSSI reference value (-100~0 dbm)
RSSI reference value (-100~0 dbm)
CHAPTER 7. WLAN Additional Services
Description
Description
Description
Description
Description
Description
page 373 of 689