Figure 101. Window For Configuring Tunneling Forwarding Of Remote Ap Group - Samsung WEC8500 Operation Manual

2) Designate the split ACL in the WLAN set with the tunneling mode.

tunneling-forwarding [WLAN-ID] [SPLIT-ACL-NAME]
3) Execute the 'show ap-group remote-forwarding [REMOTE AP GROUP NAME] '
command to check the AP group information.
4) Use the 'send-remote-acl-to-ap profile-only' command to send the ACL Profile
information of the remote AP group to APs.
5) Use the 'send-remote-acl-to-ap all' command to send the information on the ACL
Profile, Tunneling Forwarding and Local Bridging Forwarding of the remote AP group
to APs.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<AP Groups> menu in the sub-menus. After selecting the name of the remote AP group,
you can configure Tunneling Forwarding in the "ACL Profile" item of the 'Remote AP
Group' tab. In addition, you can click the "Send To APs" button to send the information on
ACL Profile, Tunnel Forwarding, and Local Bridging Forwarding to APs.

Figure 101. Window for Configuring Tunneling Forwarding of Remote AP Group

4.2.2.5 Configuring Local Bridging Forwarding of Remote AP Group
You can configure the VLAN ID, ACL, and PreAuth ACL to a WLAN set with local
bridging among WLANs included in the remote AP group.
You can use Interface Group at the Interface which is generated same Remote AP Group's
interface menu.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
page 195 of 689