No Dot1X System-Auth-Control; Dot1X Timeout - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Format
Mode

no dot1x system-auth-control

This command is used to disable the dot1x authentication support on the switch.
Format
Mode

dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set. The following tokens are supported.
• reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine
on this port to determine when re-authentication of the supplicant takes place. The reauth-
period must be a value in the range 1 - 65535.
• quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine
on this port to define periods of time in which it will not attempt to acquire a supplicant. The
quiet-period must be a value in the range 0 - 65535.
• tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to determine when to send an EAPOL EAP Request/Identity frame to the supplicant.
The quiet-period must be a value in the range 1 - 65535.
• supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine
on this port to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.
• server-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine
on this port to timeout the authentication server. The supp-timeout must be a value in the range
1 - 65535.
Default
9-10
dot1x system-auth-control
Global Config
no dot1x system-auth-control
Global Config
reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
202-10102-01, May 2005
Security Commands