Table of Contents
Advertisement
2
Hold the center of the paper guides and slide
them to the desired paper size.
3
Load the paper all the way into the tray from
the bottom edge first, with the side to be
copied or printed facing up and with the tab
portion to the left.
Important • Do not load mixed paper types in the tray.
Loading Paper in Tray 6 (A3 High Capacity Feeder (Optional))
The following describes the procedure for loading paper in Tray 6 (A3 High Capacity
Feeder (optional)).
Note
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Tray 6 (A3 High Capacity Feeder (Optional))" (P.83).
1
Pull out Tray 6 towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do
2
Remove any paper loaded in the tray.
3
With the side to be copied or printed on
facing up, load approximately 100 to 500
sheets of paper in the tray and align the
edges of the paper in the arrow direction (1).
Hold the long-side paper guide and slide it to
the desired paper size (2).
• Do not load paper exceeding the
maximum fill line. It may cause paper
jams or machine malfunctions.
• Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each
other and reduces paper jams.
not pull out the tray that the job uses.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or misloading. Remove any remaining paper from the tray, and then load the removed
paper on top of the newly loaded paper.
Loading Paper
4
71
Advertisement
Table of Contents
