RegStratOn Mark DetectOn - GRAPHTEC FC2250 Series User Manual

Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.13 Setting the Registration Mark Cutting Function
If your regstraton mark pattern s Mrror 1 or Mrror 2, the regstraton marks can be cut after they have been
detected.
(1) Select ether AXIS or MARKS for the regstraton mark mode (see Secton 4.2, "Settng the Regstraton Mark
Mode".)
(2) Wth the plotter n Ready status, press the [ORIGIN] key to dsplay the followng menu.
FORCE
1
2
SPEED
(3) Press the [NEXT] key to dsplay the followng menu.
FORCE
MIRROR MARKS
START POS
SPEED
(4) Press the [F1] key (MIRROR MARKS) to dsplay the menu for cuttng mrror marks.
FORCE
CUT MIRROR MARKS
ON
SPEED
The currently selected settng s ndcated by a black dot [
To cut a regstraton mark, press the [F2] key (ON).
If you do not wsh to cut a regstraton mark, press the [F4] key (OFF).
When the dsplayed settng s satsfactory, press the [ENTER] key to confirm your selection.
(5) When ON has been selected, a menu for settng the spacng for the selected regstraton mark mrror pattern s
dsplayed.
FORCE
MARK TYPE:MIRROR
SPACING = 3.0 mm
SPEED
Use the [ ] or [
Setting range: 0 to 9.9 (mm)
Set value
Set value
(6) After the regstraton mark has been detected, the followng menu s dsplayed. (See Secton 4.12, "Regstraton Mark
Detecton".)
FORCE
CUT MIRROR MARKS?
YES
SPEED
Press the [F2] key (YES) to perform cuttng of the detected regstraton mark.
4-24
OFFSET
3
MANUAL
QUALITY
OFFSET
QUALITY
OFFSET
OFF•
QUALITY
OFFSET
QUALITY
] key to change the numerc value, and then press the [ENTER] key to confirm your selection.
OFFSET
NO
QUALITY
•
].