GRAPHTEC FC2250 Series User Manual page 66

registration marks can be detected) but the floating up of the medium from the surface of the plotter or dirt on the
medum may cause erroneous detecton.
Make settngs for regstraton mark pattern 3, Mrror 1 and Mrror 2 n the same way.
Adjusting the Sensitivity of the Registration Mark Sensor
If you have changed the medium to a different type, we recommend that you perform this procedure.
(1) Press the [PAUSE] key to select ntl the followng menu s dsplayed.
FORCE
MARK
BUFFER CLR.
SPEED
(4) Press the [F1] key (MARK) to dsplay the regstraton mark functons selecton menu.
FORCE
MODE
TYPE OTHER SETUPS
SPEED
(5) Press the [F4] key (OTHER SETUPS) to dsplay the menu shown below.
FORCE
SIZE ADJ. SENS
ORG OFT
SPEED
(6) Press the [F4] key (SENS OPT) to dsplay the menu shown below.
FORCE
LEVEL
SENS SPD SENS STEP
SPEED
(7) Press the [F1] key (LEVEL) to dsplay the menu shown below.
FORCE
SENSOR ADJ
1,2 TYPE MIRROR
SPEED
(8) Press the [F1] key (SENSOR ADJ) to dsplay the menu for adjustng the senstvty of the sensor.
FORCE
SENSOR ADJUST
DEFAULT
SPEED
(9) To adjust the senstvty value, press the [F4] key (ADJUST) to dsplay the followng prompt. To select the default
value, press the [F2] key (DEFAULT).
FORCE
MOVE TO ADJ. POINT
PRESS ENTER KEY!
SPEED
OFFSET
TOOL U/D
VIEW
QUALITY
OFFSET
DIST ADJ
QUALITY
OFFSET
SENS OPT
QUALITY
OFFSET
QUALITY
OFFSET
TYPE 3
QUALITY
OFFSET
ADJUST
QUALITY
OFFSET
QUALITY
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4-15